JFE430LN
<Composition> 18Cr - Nb - ultra-low C (SUS 430LX)
comparison of corrosion resistance
Weldability
Corrosion resistance
- A stainless steel with enhanced corrosion resistance and weldability.
Applications
- Bicycle rims, silos, central heating pipes, etc.
Chemical composition
| Type | Standards | Chemical composition (%) | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| JFE Standards | JIS Standards | Correspoding EN Standard | ASTM AISI equivalent |
C | Si | Mn | P | S | Cr | Mo | Other | |
| Weldability Corrosion resistance |
JFE430LN | ≤ 0.030 | ≤ 0.75 | ≤1.00 | ≤ 0.040 | ≤ 0.030 | 16.00 - 19.00 | Nb 0.10 - 1.00 | ||||
Mechanical properties
| Type | Standards | Mechanical properties | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| JFE Standards | JIS Standards | Correspoding EN Standard | ASTM AISI equivalent |
Tensile test | Hardness test | Bend test | |||||
| Yield strength N/mm² |
Tensile strength N/mm² |
Elongation (%) | Hv | HRB | Bending angle | Internal radius |
|||||
| Weldability Corrosion resistance |
JFE430LN | ≥ 175 | ≥ 360 | ≥ 22 | ≤ 200 | ≤ 88 | 180° | 1.0×t | |||
Physical properties
| Steel grade | Density | Electrical Resistance | Magnetism | Specific heat | Thermal conductivity | Thermal expansion coefficient | Young’s modulus | ||
|---|---|---|---|---|---|---|---|---|---|
| 0 - 100℃ | 100℃ | 500℃ | 20 - 100℃ | 20 - 650℃ | ×10³ | ||||
| g/cm³ | 10-6Ω・cm | (Annealed material) | J/kg・℃ (cal /g-℃) |
W /m・℃ (10-2cal/cm-sec-℃) |
10-6/℃ | N/mm² | |||
| JFE430LN | 7.70 | 60.5 | Yes | 460 （0.11） |
23.1 （5.53） |
26.3 （6.28） |
10.5 | 12.2 | 196 |
<<Note>> Density in the table above is the actually measured value as a physical property.
In mass calculations for commercial transactions, JIS G 4310 “Method of Mass Calculation for Stainless Steel Plates and Sheets, and Heat-Resisting Steel Plates and Sheets” will apply.
In mass calculations for commercial transactions, JIS G 4310 “Method of Mass Calculation for Stainless Steel Plates and Sheets, and Heat-Resisting Steel Plates and Sheets” will apply.