■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol. 23(1991) No.4
■■■■■■■■■■■■■■■■■■■

片テーパ付ワークロールシフトミルによる薄鋼板のエッジドロップ制御特性
Edge-Drop Control of Hot and Cold Rolled Strip by Tapered-Crown Work Roll Shifting Mill

北村 邦雄(Kunio Kitamura) 鑓田 征雄(Ikuo Yarita) 菅沼 七三雄(Namio Suganuma) 中西 敏修(Toshinobu Nakanishi) 豊島  貢(Ko Toyoshima)
要旨 :
薄鋼板の分野においてはエッジドロップと呼ばれる板幅端部における板厚の急激な減少を改善することが,重要な課題となっている。そこで板幅端部の変形挙動を調査し,さらにラボミルおよび実機ミルにおいて片テーパ付ワークロールシフトミルによるエッジドロップの制御特性を検討した。その結果,エッジドロップは板幅端部の3次元メタルフローによって生じ,ワークロールの扁平変形に大きく影響される。冷間タンデムミルにおいては,前段スタンドから片テーパ付ワークロールシフトミルを適用することにより,エッジドロップを顕著に改善できる。また,ホットストリップミルにおいても,片テーパ付ワークロールシフトミルはエッジドロップの改善に有効であることが判明した。
Synopsis :
Hot and cold rolled strip is demanded to remove the edge-drop which is a nonuniformity of the transverse strip thickness profile at strip edges. The deformation behaviour in strip edges is experimentally studied, and characteristics of edge-drop control by the tapered-crown work roll shifting mill are investigated in a laboratory mill and commercial cold and hot strip rolling mills. The results are as follows: (1) Three dimensional material flow occurs at the strip edge and the material flow causes to the edge-drop, (2) the edge-drop is primarily affected by changes in the work roll profile resulting from roll flattening, (3) the tapered-crown work roll shifting mill is effective in removing the edge-drop, (4) in the tandem cold mill, it is necessary to install the work roll shifting mill from the first stand to successive stands to obtain the edge-drop-free strip, and (5) in the hot strip mill, the work roll shifting mill is also necessary to remove the edge-drop.
本文(PDF: 7P/270kb)




(c)JFE Steel Corporation, 2003