■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.30 (1998) No.3
■■■■■■■■■■■■■■■■■■■

予熱低減型 HT980 鋼板および溶接材料の特性と水圧鉄管への適用性
Properties of HT980 Steel Plates and Welding Materials with Low Cold Cracking Susceptibility and Their Applicability to Penstocks

板倉 教次(Noritsugu Itakura) 安田 功一(Koichi Yasuda) 青木 雅弘(Masahiro Aoki)
要旨 :
水圧鉄管用として,割れ阻止予熱温度低減化要求に応え,板厚 50 および 75 mm の予熱低減型 HT980 鋼板およびその SMAW,SAW,MAG 溶接および TIG 溶接用材料を開発した。y 形溶接割れ試験の割れ阻止予熱温度は SMAW で 75。C(吸湿なし,雰囲気:30。C,湿度 80%),また MAG および TIG 溶接では 50。C 以下であり,HT780 鋼と同等の耐溶接割れ感受性を有している。母材および溶接継手の機械的特性は目標を十分に満足した。また作用応力 400 MPa,0。C の条件で,溶接部は長さ 30 mm,深さ 10 mm の表面欠陥からの脆性破壊発生阻止性能を,母材は WES3003A 種基準を満たす脆性破壊停止性能を有していた。
Synopsis :
50 and 75 mm thick HT980 steel plates and welding materials for SMAW, SAW, MAG and TIG welding have been developed to meet the demand of saving preheating costs in constructing penstocks. Preheating at 75。C prevented cold cracking in a y-slit crack test performed by SMAW in a stringent atmosphere of 80% humidity and 30。C. No cracking was also observed in y-slit crack tests performed by MAG and TIG welding with a preheating temperature of 50。C. These results prove that the weldability of the new type HT980 is as good as that of HT780. The base metal and the welded joints satisfied the target mechanical properties. The fracture toughness of the welded joints proved that the applied stress of 400 MPa does not initiate brittle fracture from a 30 mm long and 10 mm deep surface crack at 0。C. The crack arrest toughness of the base metal satisfied the WES3003 Grade A specification.
本文(PDF: 7P/340kb)




(c)JFE Steel Corporation, 2003