■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.28 (1996) No.2
■■■■■■■■■■■■■■■■■■■

冷間タンデムミルにおける難圧延材の高精度プロフィル制御技術
Development of Advanced Transverse Thickness Profile Control of Thin Hard Steel Strips at Tandem Cold Rolling Mill

蛭田 敏樹(Toshiki Hiruta) 赤木  功(Isao Akagi) 水島 成人(Narihito Mizushima)
要旨 :
川崎製鉄水島製鉄所の4スタンド6段圧延機からなるNo.2冷間圧延設備において,片テーパ付きワークロールシフト圧延法を適用し,ワークロールプロフィルを最適化することにより,冷間圧延において鋼板の板幅方向プロフィル制御範囲を拡大した。さらに熱延鋼板のクラウンの大きさに対応したワークロールシフト位置を制御するエッジドロップのフィードフォワード制御,ミル出側に配置したエッジドロップ計を用いたエッジドロップのフィードバック制御を確立した。これら冷間圧延におけるエッジドロップ制御システムを構築したことにより,薄物難圧延材の板幅方向の全長,全幅にわたり,定常部で0.5%以内,非定常部で0.8%以内の高い板厚精度を達成した。
Synopsis :
At No.2 tandem cold rolling mill, consisting of four 6-high stand mills, in Mizusima Works of Kawasaki Steel, by applying a one-side tapered work roll shifting method (K-WRS) and by using suitable taper profile of the work rolls, edge drop control range in cold rolling has been expanded. Furthermore, a feed-forward edge drop control system, corresponding to the amount of crown of hot-rolled material, and a feed-back edge control system using an edge drop sensor, have been established in the tandem cold rolling mill. Consequently, thickness accuracy in transverse derection has been achiebed within 0.5% in a steady rolling state (at a middl part of a strip) and within 0.8% in a non-steady rolling state (at lead and tail ends of a strip) over the full length of the thin hard steel strip product.
本文(PDF: 5P/230kb)




(c)JFE Steel Corporation, 2003