■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.27 (1995) No.3
■■■■■■■■■■■■■■■■■■■

プレス加工用TS440MPa級冷延鋼板の開発
Development of TS 440 MPa Grade Cold Rolled Sheet Steels with Excellent Formability

瀬戸 一洋(Kazuhiro Seto) 奥田 金晴(Kaneharu Okuda) 坂田  敬(Kei Sakata)
要旨 :
自動車内・外板用に適用しうる優れた成形性を有するTS440MPa級高強度冷延鋼板の開発を目的として,極低酸素IF鋼の機械的特性に及ぼすMn添加の影響を検討した。0.002%C−0.5%Si−0.1%P鋼をベースにすると1.2%以上のMn量で440MPaを上回る引張強度が得られる。Mn量が1.5%のとき,Ar(3)変態点が約800℃となり,熱延後の組織が細粒化するため,冷延・焼鈍後に優れた全伸び(EI)およびγ値が得られる。すなわち,良好な加工性を得るためにはフェライト安定化元素(P,Si)とオーステナイト安定化元素(Mn)をバランスさせて変態点を制御することが重要である。上記の結果をもとに実機製造した鋼板は1.9以上の高γ値が得られ,他の特生も自動車用として優れたものであった。
Synopsis :
Effect of Mn content on mechanical properties in interstitial atom free steel has been investigated to develop deep-drawable 440 MPa TS grade high strength cold-rolled sheet steels applicable to automotive panels. The 440 MPa grade in tensile strength can be attained by Mn addition of more than 1.2% in the 0.002%C-0.5%Si-0.1%P steel. Large total elongation and high γ-value are obtained by 1.5% Mn addition because the Ar3 transformation temperature is controlled at about 800℃ and the micro-structure of steel is refined after hot rolling. Thus, for obtaining excellent formability, it is especially important to optimize the austenite-ferrite transformation temperature by adjusting the addition of both the ferrite (Si, P)- and the austenite (Mn)-stabilizing elements in the proper range. As a result, 440 MPa TS grade steel with a high γ-value of 1.9 can be developed, leading to successful application to automotive parts which require both higher strength and excellent formability.
本文(PDF: 7P/318kb)




(c)JFE Steel Corporation, 2003