■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol. 22(1990) No.3
■■■■■■■■■■■■■■■■■■■

高硬度耐摩耗鋳鉄の開発
Manufacture of Large Roller Tires of Ni-Hard White Cast Iron and 20% Cr White Cast Iron for Coal Pulverizer

斉藤  博(Hiroshi Saito) 新中 博昌(Hiromasa Niinaka)
要旨 :
従来製品に比べて2倍の粉砕能力を有する大型ローラーミル用ニハード鋳鉄および高Cr鋳鉄タイヤの製造条件を確立するため,両材質の大型化に伴う問題点を把握し,試作・確性試験を行った。これらの材質は〔C〕の晶出が起こらないため一般の鋳鉄よりひけ巣が発生しやすく,またCrを大量に含むため湯ジワ欠陥も発生しやすい。さらに,Mf点が常温以下となるため除冷中に変態が起こり,大きな変態応力による割れ発生の危険がある。そこで,凝固解析による鋳造方案の最適化,鋳造時の冷却方法および適切な熱処理条件の選定などについて十分に考慮した。その結果,両材質とも健全な製品が得られ,目標どおりの性能を達成した。
Synopsis :
Solidification characteristics and the effects of the cooling rate during heat treating and chemical composition on mechanical properties were investigated to develop the manufacturing procedure of Ni-hard white case iron and 20% Cr white iron for large roller tires of a coal pulverizer. Casting defects, such as internal shrinkage and the elephant skin which were typical characteristics in those types of cast iron, were able to be minimized by optimization of the solidification procedure using our calculation system called "BACCAS" and by control of the atmosphere during teeming. Thermal cracking, which was apt to occur during cooling after casting and heat treatment, in those cast irons was prevented by severe temperature control during both kinds of cooling. On the basis of these preproduction test results, both types of trial casting resulted in excellent quality with sufficient hardness.
本文(PDF: 6P/290kb)




(c)JFE Steel Corporation, 2003