■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.21 (1989) No.4
■■■■■■■■■■■■■■■■■■■

電子写真用フェライトキャリアの特性による複写機の現像性の制御
Dependence of Xerographical Developability on Ferrite Carrier Properties

藤長 政志(Masashi Fujinaga) 奥埜 計造(Keizou Okuno) 池田 隆雄(Takao Ikeda) 星原  泉(Izumi Hoshihara) 池田 義俊(Yoshitoshi Ikeda)
要旨 :
電子写真現像剤用のキャリアとして,鉄粉に代わってフェライトキャリアが広く用いられているが,その画像特性は明らかでない。フェライトキャリアの特性が,電子写真の現像性におよぼす影響を解明するため,市販複写機を用いて,当社が開発したフェライトキャリヤの諸特性による複写画像の濃度,階調性,回収トナー量の変化を調べた。画像濃度はキャリアの誘電率と粒径で変化し,高誘電率,小粒径で向上する。階調性は粒径と粒度分布に依存し,大粒径で軟調となった。回収トナー量は,キャリアの表面状態で変化するトナーの電荷分布の影響を受け,分布がブロードになると増加する。キャリア表面の結晶粒径を同程度としたとき,回収トナー量は最小となった。
Synopsis :
The dependence of xerographical developability on carrier properties has been studied using commercial plain paper copiers. Recently the steel beads carrier has been replaced by a ferrite carrier as a xerographic developer, but the developability of the latter has not yet been clarified. Measurements of image density, print contrast and the residual toner mass have been made to elucidate the relationship between characteristics of the ferrite carrier and its developability. The image density increases, as the dielectric constant of the developer increases and the diameters of carrier beads decrease. The contrast of the print becomes flatter with an increase in the carrier beads diameter. The residual toner mass increases as the toner charge distribution broadens. Surface condition of carrier beads affects the toner charge distribution, and the minimum residual toner mass is attained, when the sizes of carrier surface grains are similar to those of toner particles.
本文(PDF: 5P/348kb)




(c)JFE Steel Corporation, 2003