■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.21 (1989) No.3
■■■■■■■■■■■■■■■■■■■

冷延鋼板の連続焼鈍技術の進歩と材料開発
Progress of Continuous Annealing Technology for Cold-Rolled Sheet Steels and Associated Product Development

阿部 英夫(Hideo Abe) 佐藤  進(Susumu Sato)
要旨 :
冷延鋼板の連続焼鈍技術の歴史をおもに金属学的見地から,またこれを用いた材料開発を製造原理を中心に解説した。(1)1936年Hagueらにより低炭素鋼を過時効処理することを特徴とする製造原理が提案され,1970年代に日本で冷延鋼板用連続焼鈍ラインが実現した。(2)連続焼鈍の急冷処理を利用して複合組織高強度鋼板が開発された。(3)低炭素鋼の熱延高温巻取処理および急冷過時効焼鈍により,絞り用鋼板(DQ以下グレード)が製造されている。(4)Ti,Nb添加極低炭素鋼により過時効なしでCQ〜EDDQ鋼板が製造されている。(5)Nb添加極低炭素鋼のNbCを再結晶温度以上の高温で溶解させ,かつ急冷することにより,BH型超深絞り用鋼板が開発された。(6)生産性および製品品質の観点から,今後も大幅な連続焼鈍化が予想される。
Synopsis :
Hastoy of continuous annealing (CA) technology has been reviewed from a metallurgical viewpoint, and manufacturing principles for some new products developed by CA process are described as follows: (1) In 1936, Hague et al, proposed the CA principle characterized by the process including over-aging. Commercial CA lines for cold-rolled sheet were installed at Japanese steel companies in the 1970s. (2) Dual-phase high-strength steels were developed by applying the rapid cooling potential. (3) Drawing quality steels (below DQ grade) with low C steels, hot-coiled at a high temperature, were produced by the CA process including rapid cooling and over-aging. (4) Ti- and/or Nb-added extra-low C steels provided CQ to EDDQ grade sheet steels with no over-aging CA process. (5) Bake-hardenable and extra-deep-drawable steels were developed by the high temperature CA process with Nb-bearing extra-low C steels. (6) From the view points of productivity and product quality, it is predicted that the CA process will globally evolve in the future.
本文(PDF: 8P/400kb)




(c)JFE Steel Corporation, 2003