■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.21 (1989) No.2
■■■■■■■■■■■■■■■■■■■

レーザ発光分光分析による溶銑の直接分析
Direct Analysis of Molten Iron by Laser Emission Spectrometry

谷本  亘(Wataru Tanimoto) 山本  公(Akira Yamamoto) 角山 浩三(Kouzou Tsunoyama)
要旨 :
溶融金属を試料採取することなく分析する直接分析法として,レーザー光を励起源とした発光分光分析法を開発した。大出力パルスレーザ光を出力2Jで試料表面に集光照射すれば,効率よく励起できること,励起光のうち,レーザー光照射直後の1μsec間には,強い連続光が放出され,その後放出される光を分析に用いれば,固体,溶融状態試料の定量分析ができることを明らかにした。sらに高炉鋳床で溶銑を直接分析する際の湯面の上下動,湯面角度,湯温の変化による影響を受けないことを確認した。スキンマ通過直後の湯溜りにおいて現場実験し,Cを±0.1 Wt. %,Si, Mn, Pを±0.2 Wt.%, Sを±0.1 Wt.%の誤差で分析できた。
Synopsis :
An application of a laser emission spectrometry to the in situ analysis of the molten metal was investigated. Effective exitation of the samples was achieved by using a Q-switched-pulse, high energy (2J) laser beam. It was found that strong and continuous emission light appeared for 1 μsec after irradiation, which caused poor accuracy. The analytical accuracy was greatly improved by measuring the light emitted after initial 1μsec of the emission.This method was not disturbed by the fluctuations of the surface level, tilt angles and temperatures of the molten metal during the continuous analysis. The analytical error was ±0.1 Wt. % for C, ±0.2 Wt. % for Si, Mn, P and ±0.1 Wt. % for S when the molten iron was analyzed continuously at a skimmer of the blast furnace.
本文(PDF: 7P/276kb)




(c)JFE Steel Corporation, 2003