■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.20 (1988) No.3
■■■■■■■■■■■■■■■■■■■

副生ガス焚きコンバインド発電設備
A 145MW By-Product Gas Firing Gas Turbine Combined Cycle Plant

天野  忍(Shinobu Amano) 高野 英樹(Hideki Takano) 小林 侃二(Kanji Kobayashi) 廣崎 雅直(Masanao Hirosaki) 阿部 成雄(Shigeo Abe) 沖汐 正悦(Masaetsu Okishio)
要旨 :
副生ガスの有効利用と老朽化した発電所のリプレースを目的として,千葉製鉄所に出力145MWの大容量・高効率のガスタービンコンバインド発電プラントを建設した。導入にあたっては,燃焼実験による低NOx・低カロリー副生ガス焚き燃焼器の選定,一軸型の採用,エネルギーセンターからの遠隔自動化などの新しい技術を取り入れ製鉄所のエネルギーコストの低減を目指した。その結果,発電所送電端熱効率は46%(低位発熱基準)以上を達成し,通常の副生ガス焚き発電所よりも相対値で10%以上も高い値を実現した。
Synopsis :
A large scale and highly efficient 145-MW blast furnace gas firing gas turbine combined cycle plant was installed in Chiba Works for the purpose of utilizing the by-product gas effectively and renewing the old power plant. When installing the combined-cycle plant, Kawasaki Steel adopted new technologies such as u low NOx combustor of the low-calorific-value by-product gas, single shaft combined-cycle arrangement and automatic remote control from the energy center, and also aimed at reducing energy cost in the steelworks. As a result of introducing the gas-turbine combined-cycle plant, a plant thermal efficiency of above 46%(at LHV) was achieved, which was above 10%, at a relative value, higher than a general by-product gas firing power plant.
本文(PDF: 7P/388kb)




(c)JFE Steel Corporation, 2003