■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.17 (1985) No.3
■■■■■■■■■■■■■■■■■■■

デルタフェライトを含有するオーステナイトステンレス鋼の熱間加工性
Hot Workability of Austenitic Stainless Steels Containing Delta Ferrite

川崎 龍夫(Tatsuo Kawasaki) 高田  庸(Isao Takada) 大坪  宏(Hiroshi Ohtsubo) 鈴木 重治(Shigeharu Suzuki)
要旨 :
熱間圧延で割れが問題となるオーステナイト系ステンレス鋼の高温変形態について調べた。変形態はSにより著しい影響を受け,高温加熱後の冷却中に,1050℃を中心とした脆化域を作る。この脆化はオーステナイト単相のものでは温度低下とともに回復するが,デルタフェライトが存在すると低温側に拡大する。これらの現象を,Sとデルタフェライトの複合効果として検討を加えた。この種のステンレス鋼の高温変形態は,Sの影響さえ完全に取除けば飛躍的に向上し,通常の熱間圧延でも割れが発生しなくなる。そのためには10ppm程度以下の極低Sとし,さらにCaまたはREMの添加を行えばよい。
Synopsis :
Hot workability of austenitic stainless steels, which have problems of cracking when they are hot rolled, is studied. Sulfur has a great effect on hot workability and decreases ductility of steels at around 1050℃ during cooling from the slab reheating temperature. For steels containing little delta-ferrite, the ductility increases again as the temperature decreases. For steels containing delta-ferrite, however, ductility does not increase again. Then, the temperature range of reduced ductility for these steels expands widely towards lower temperatures. The effects of S and delta-ferrite on hot workability are discussed. Hot workability of these steels are improved remarkably by eliminating the effect of S. Problems of cracking during hot working can be solved completely by reducing S content to below about 10 ppm and/or with the addition of Ca or REM.
本文(PDF: 9P/457kb)




(c)JFE Steel Corporation, 2003