■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.16 (1984) No.2
■■■■■■■■■■■■■■■■■■■

LD転炉の上底吹き転炉(K-BOP)化における設計・施工
Planning and Execution in Reconstruction of Combined Blowing Process (K-BOP) from LD Process

田中 秀幸(Hideyuki Tanaka) 岩谷 明之(Toshiyuki Iwatani) 陶山 謙一(Ken-ichi Suyama) 有吉 政弘(Masahiro Ariyoshi) 秋山 信治(Shinji Akiyama) 武  英雄(Hideo Take)
要旨 :
水島製鉄所では,第2製鋼工場の転炉3基を1984年3月までにK-BOP化して,順調な操業を続けている。この改造工事にあたっては,炉体改造のための強度検討をはじめ,配管設備,非常設備,ボトムメンテナンス設備等の付帯設備に関しても可能な限り社内施工とするように努めた。その結果,LD転炉のK-BOP化を計画から製作まで,一括して施工できる技術を確立した。強度検討は,FEMを用いて温度分布を考慮した応力解析を実施し,工事は,設備停止をすることなく6回の炉修期間を利用して実施した。予想された炉体振動は,操業方法や羽口配列の改善等の対策により解決し,高い生産性と優れた経済性を維持している。
Synopsis :
In Mizushima Works, all three LD converters of No.2 BOF shop were remodeled into K-BOP's (combined blowing processes) by March 1984, and have continuously been operating satisfactorily. Way of design and execution in bulk for remodeling LD's into K-BOP's was successfully established through this reconstruction by organizing self-executing formation, for instance, the dynamic analysis of the vessel, arrangement of environmental equipment and decision of specifications of incidental facilities which include piping, stand-by equipment and bottom maintenance equipment. To remodel the vessel, dynamic analysis was done by heat and stress analysis using FEM. The reconstruction was executed during two times of relining for each converter, without incurring any operation disturbance. Although vessel vibration was expected, it was fully solved by improvement in operation and design of tuyere arrangement. Three K-BOP's have been maintaining high productivity and economy in steel making.
本文(PDF: 8P/378kb)




(c)JFE Steel Corporation, 2003