■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.14 (1982) No.1
■■■■■■■■■■■■■■■■■■■

数値制御式ティンプレートシャーの開発
Development of Numerically Controlled Rotary Shear for Tinplate

嶺   義輔(Yoshisuke Mine) 井田 幸夫(Yukio Ida) 山本 博正(Hiromasa Yamamoto) 金井 正治(Masaharu Kanai) 大川 順弘(Yoshihiro Okawa) 東    将(Susumu Azuma)
要旨 :
錫メッキ,クロムメッキ鋼板の剪断長さ精度の向上のため,数値制御式ティンプレートシャーを開発し,実用化した。本シャーは,シャードラム駆動モータと鋼帯搬送モータを独立させ,鋼帯の送り速度を検出し,設定剪断長さになるように剪断周期を数値制御している。また,ナイフ周速度と鋼帯の送り速度の同期は,ドラム駆動サーボモータを加減速させるのではなく,ドラム駆動系に非円形ギアを組み込みサーボモータを定速回転させている。この結果,実用化されている小容量,低慣性モータの使用で,高い剪断長さ精度と既存の機械式シャーと同等の剪断速度を得ることができた。
Synopsis :
Lately user's demands for accuracy in cut length of tinplates have become increasingly severe. Most of the conventional mechanical shears for tinplates, however cannot meet the user's requirements. The authors have developed a numerically controlled rotary shear of a new type for tinplates to achieve high accuracy in cut legth. In this shear, a DC servo motor driving the shear drums is numerically controlled in accordance with the material speed, and this synchronization in speed between the meterial and the knife during cutting is implemented by non-circular gears and by electrically controlling the speed of the DC servo motor. Even though the use of the DC servo motor of a small capacity, the technical concept mentioned above has attained high accuracy in cut length and a wide range of cut lengths at high speed.
本文(PDF: 8P/190kb)




(c)JFE Steel Corporation, 2003