■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.14 (1982) No.1
■■■■■■■■■■■■■■■■■■■

新設の千葉製鉄所第3連続鋳造設備
Intoroducing No.3 Continuous Slab Caster at Chiba Works

三枝   誠(Makoto Saigusa) 数土 文夫(Fumio Sudo) 福永 一朗(Ichiro Fukunaga) 守脇 広治(Hiroji Moriwaki) 斉藤 貞之(Sadayuki Saito) 安川   登(Noboru Yasukawa)
要旨 :
千葉製鉄所第3連鋳設備は,純酸素底吹転炉2基を有する第3製鋼工場に建設され,昭和56年4月2日に稼動して以来順調な操業を続けている。本連鋳機は,高速鋳込み時にも優れたスラブ内質を確保するため,3mの垂直部を持つ漸次曲げ―漸次矯正プロフィールとし,またロールピッチの縮小をはかるため,分割ロールを採用した。また,スラブ温片装入を促進するために,トーチカットスラグ除去装置,迅速テストスカーフ設備などを有する精製ヤードを設けた。純酸素底吹転炉においては,純酸素上吹転炉に比較し鋼中酸素が高くなりがちなため,スラブの表面品質が懸念されたが,転炉操業技術を改善することにより解決し,良好な品質のスラブを得ている。
Synopsis :
A No.3 continuous slab caster was constructed at Chiba Works, Kasawaki Steel Corp. as part of the No.3 Steelmaking Shop where two Q-BOP converters are in operation. Following its start in April, 1981, the caster has been operating satisfactorily. This machine has the 3 meter vertical portion, progressive bending-unbending profile, and the small roller pitch with divided rollers. All these are designed to produce excellent internal quality slabs at high speed casting. The slab conditioning equipment is installed for a quick test scarfing so as to charge the slabs in hot codition to the heating furnace. In case of the Q-BOP steels, hydrogen content is apt to be rather higher than that of LD; therefore, the surface defect of slabs was a possible problem, but this defect is solved by the improvement of Q-BOP operation itself.
本文(PDF: 10P/278kb)




(c)JFE Steel Corporation, 2003