■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.13 (1981) No.2
■■■■■■■■■■■■■■■■■■■

新しいコークス強度推定法の開発
Development of a New Method for the Predicting of Coke Strength

杉辺 英孝(Hidetaka Suginobe) 宮川 亜夫(Tsuguo Miyagawa) 堀越 英生(Hideo Horikoshi) 安部 幹夫(Mikio Abe) 滝沢   譲(Yuzuru Takizawa) 伊神 峰生(Mineo Ikami) 笠岡 玄樹(Shizuki Kasaoka) 青山 充三(Yorimitsu Aoyama)
要旨 :
コークス強度(DI30/15)を石炭性状と操業因子から予測する新しい試みを示した。コークス化過程と(DI30/15)の理論的考察によると,セミコークスの引張強度と生成熟応力が(DI30/15)に影響する主因子である。それぞれの因子は石炭の流動性と揮発分から算出される組織学的パラメータ,装入炭の粉砕度,コークス炉のフリュー温度,および数学的に定義される装入炭の不均質性,で表される。この考察に基づいて(DI30/15)推定式の一般的な形を組立てた。実用上の目的から,式中の各係数はデータの解析で決定されている。正確さと簡便性のため,この推定式は工場における操業に利用されている。
Synopsis :
A new approach is shown to predict coke strength (DI**30)(DI**15) fromm coal quality and working conditions. Theoretical consideration of coking process and (DI**30)(DI**15) shows that (1) tensile strength of semi-coke and thermel stress generated in semi-coke are factors effcting on (DI**30)(DI**15) and (2) each factor is expressed by petrographical parameters derived from fluidity and the volatile matter of coal, the crushing degree of the charge, flue temperature in the coke oven and inhomogeneity of the charge which is defined mathematically. An equation for predicting (DI**30)(DI**15) is general form based upon the above consideration. For practical purposes, each coefficient in the equation is determined by data analysis. Because of its accuracy and simplicity, this equation is being utilized satisfactorily in operation at works.
本文(PDF: 10P/343kb)




(c)JFE Steel Corporation, 2003