■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.12 (1980) No.3
■■■■■■■■■■■■■■■■■■■

溶融特性制御による連鋳モールドパウダーの開発
Development of Mold Powders for Continuous Casting by Controlling Melting Characteristics

桜谷 敏和(Toshikazu Sakuraya) 江見 俊彦(Toshihiko Emi) 武  英雄(Hideo Take) 江本 寛治(Kenji Emoto) 越川 隆雄(Takao Koshikawa)
要旨 :
モールドパウダーの溶融挙動を高温顕微鏡により調査した。骨材炭素粉配合法に応じて溶融曲線が大きく変化することを見出し,その溶融特性を示す値として半溶融層形成過度域THMを得た。THMは実機の溶鋼面上でのパウダー溶融挙動を理解するのに有用であるばかりでなく,鋳片表面欠陥の発生率もこれに対応することが認められた。安定した溶融スラグ層を形成するためには半溶融層の構造を的確に制御すべきとの考えに基づき,高速連鋳用パウダーを開発した。
Synopsis :
The melting behavior of mold powder was investigated in the hot stage microscope during the course of heating. The melting curve and the characteristic value of melting, THM (temperature range of half molten layer), both of which were strongly influenced by the blending method of carbon particles acting as skelton, were derived. Experiments on the factories showed that the THM was useful for interpreting the actual melting behavior of powders on meniscus and that the occurrence frequency of surface defects on slabs depends on the characteristic value. Powders for high speed continuous casting have been developed based on the knowladge that the structure of half molten layer must be controlled adequately so as to show little fluctuation in the thickness of molten slag layer.
本文(PDF: 8P/249kb)




(c)JFE Steel Corporation, 2003