■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.12 (1980) No.2
■■■■■■■■■■■■■■■■■■■

高感度水浸Cスキャン超音波探傷装置
Immersion Type, C-scan Ultrasonic Testing Equipment

宇野 義雄(Yoshio Uno) 森田 博之(Hiroyuki Morita) 松本 延雄(Nobuo Matsumoto) 永倉 義之(Yoshiyuki Nagakura) 川村 紘一(Koichi Kawamura) 丸山 英雄(Hideo Maruyama)
要旨 :
水中に浸漬した鋼板の微細な内部欠陥を,焦点型探触子により高感度に検出し欠陥の有無を2次元的に記録する「高感度水浸Cスキャン超音波探傷装置」を川鉄計量機鰍ニ共同で開発した。本装置の特長は,厚さ1.0mm の薄鋼板から40mm までの厚鋼板に対し,0.2mm 以上のスリット標準疵の探傷が可能であり,板厚不幸の不感帯は0.3mm にすぎないこと,記録が鮮明で分解能が高く,かつ拡大,縮小記録ができることなどである。稼動後2年の現在,HIC 試験週程での割れ面積率測定や,微細欠陥の切断観察に大きく貢献している。
Synopsis :
Kawatetsu Metrological Equipment & Vending Machine Co.,Ltd. has developed a new immersion type C-scan ultrasonic testing equipment in cooperation with Kawasaki Steel Corp. The equipment with a focusing type sensitive probe defects fine internal detects of the steel plates from 1.0mm to 40mm in thickness immersed in a water bath. The equipment is featured by: (1) High sensitivity to be able to detect even 0.2mm slit, (2) Small surface dead zone of 0.3mm in thickness to enable the inspection of a plate even 1.0mm in thickness, and (3) High resolution of the recording map together with easiness of either magnification or reduction in printing size. The equipment has been making a great contribution to the measurement of crack area ratio in hydrogen induced cracking test and to the determination where to cut out microscopic samples including a micro defect just on the section.
本文(PDF: 8P/363kb)




(c)JFE Steel Corporation, 2003