■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.12 (1980) No.2
■■■■■■■■■■■■■■■■■■■

食塩水中の304ステンレス鋼の応力腐食割れにおよぼす塩素イオン濃度と温度の影響
Influence of Chloride Content and Temperature on Stress Corrosion Cracking of 304 Stainless Steel in Sodium Chloride Solution

増尾  誠(Makoto Masuo) 小野  寛(Yutaka Ono)
要旨 :
304ステンレス鋼のTIG 突合せ溶接験片のスポット溶接験片の応力腐食割れ発生に及ぼすCl(-)濃度と温度の影響を10〜21000ppmCl(-),40〜80℃の範囲で調べた。腐食活動状況はカップル電流で追跡した。TIG試験片を気液界面に浸漬すると80℃の21000ppm Cl(-)では応力腐食割れを生じた。しかし,酸洗して溶接時の酸化皮膜を除去したりあるいは液中浸漬すると応力腐食割れは起こらなかった。スポット溶接試験片の界面浸漬では80℃の1000と21000ppm Cl(-)に応力腐食割れを生じた。孔食腐食は割れより広い範囲で生じた。応力腐食割れあるいは孔食は隙間,表面状態,浸漬条件などの腐食側の条件に依存することがわかった。
Synopsis :
The occurrence of stress corrosion cracking (SSC)in TIG butt-welded specimens and spot-welded specimens of Type 304 stainless steel was investigated by the use of sodium chloride solutions containing 10,100,1000 and 21000ppm Cl(-) at 40,60 and 80℃. The extent of corrosion activity during test period was examined by the measurement of galvanic couple current between the welded specimen and the counter specimen of the same kind of steel. In TIG butt-welded specimens SCC occurred at the interface of air and 21000ppm Cl(-) solution at 80℃. However, no SCC was observed in all test conditions when the oxide film of welded specimens was previously removed by acid pickling or the total immersion test was conducted. In spot-welded specimens SCC occurred at the interface of air and the solutions containing 1000 and 21000ppm Cl(-) at 80℃. Pitting corrosion was also observed in wider range of temperature and chloride content than in the case of SCC.
本文(PDF: 7P/293kb)




(c)JFE Steel Corporation, 2003