■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.12 (1980) No.1
■■■■■■■■■■■■■■■■■■■

耐溶接割れ性60kgf/mm2級調質高張力鋼 RIVER ACE 60A,62A の諸特性
Properties of Crack-Free Type High Strength Steel Plates RUVER ACE60A,62A

広瀬 圭介 (Keisuke Hirose) 奥村 健人 (Taketo Okumura) 元田 邦明 (Kuniaki Motoda) 平井 征夫 (Yukio Hirai) 鎌田 晃郎 (Akio Kamada)
要旨 :
溶接時の低温割れや,溶接熱影響部に発生する硫化物応力腐食割れ(SSCC)への耐性を強化した耐溶接割れ性60キロ調質高張力鋼RUVER ACE60A,62Aを開発した。C含有量を0.09%以下とし,微量添加で強度上昇の著しいBを添加して溶接割れ感受性組成Pcmを0.20%以下としたことにより,38mm以下の板厚では,予熱なしで溶接が可能である。またC含有量を低く抑えた結果,溶接熱影響部の硬度も低く,耐SSCC特性に優れている。本報告では,板厚38mmの母材特性,溶接部特性を中心に,板厚100mmの極厚材の製造実績についても言及した。
Synopsis :
A crack-resistant 60kg/mm**2 tensile strength steel has been developed to prevent cold crecking of welds and sulfide stress corrosion cracking which occurs at heat affected zone under a specific corrosive enovironment. Cracking parameter (Pcm) of this material is restricted under 0.20% by a decrease in carbon content and an addition of boron. Consequently, a plate below 38mm thickness can be welded without preheating, and sulfide stress corrosion cracking resistance is excellent because of lower maximum hardness in heat affcted zone. This report also describes general characteristics of the newly developed steel plates of 38mm and 100 thickness.
本文(PDF: 10P/298kb)




(c)JFE Steel Corporation, 2003