■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.12 (1980) No.1
■■■■■■■■■■■■■■■■■■■

圧力容器用Cr-Mo鋼の焼もどし脆化感受性
Temper Embrittlement of Cr-Mo pressure Vessel Steels

佐藤 新吾 (Shingo Sato) 榎並 禎一 (Teiichi Enami) 松居  進 (Susumu Matsui) 朝生 一夫 (Kazuo Aso) 楠原 祐司 (Yuji Kusuhara)
要旨 :
圧力容器用Cr-Mo鋼のなかで焼もどし脆化感受性の高い2-1/4Cr-Mo鋼について,脆化特性におよぼすSi,Mn,Pおよびオーステナイト化温度の影響を調査し,以下の結果が得られた。(1) Si,MnあるいはP量の減少は脆化感受性を低めるが,SiあるいはMn量の減少は強化を低下させる。(2) オーステナイト化温度の上昇は強度を高めるが,脆化感受性も高める。これらの結果をもとにして,P量のみを十分減少させるか,あるいはSi,MnおよびP量を減少させたうえでオーステナイト化温度を高めれば,高温度を有しかつ脆化感受性の低い鋼を製造できることを示した。
Synopsis :
An investigation has been made of the influence of silicon, manganese, phosphorus and austenitizing temperature on the temer embrittlement of 2-1/4Cr-1Mo steel which is well known for its higher susceptibility to the embrittlement among Cr-Mo pressure vessel seels. According to this investigation the following tendency is obseved. (1) Decrease in silicon, manganese or phosphorus content lowers the susceptibility. However, lowering of silicon or manganese content decreases the strength. (2) Though increase in austenitizing temperature promotes the suscepitibility, this procedure increases the strength. It is concluded that Cr-Mo steels with high strength and low susceptibility to temper embrittlement can be obtained by lowering phosphorus content sufficiently or quenching from higher austenitizing temperature under the condition of low silicon, manganese and phosphorus contents.
本文(PDF: 10P/379kb)




(c)JFE Steel Corporation, 2003