■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.11 (1979) No.2
■■■■■■■■■■■■■■■■■■■

定点黒体炉の利用による放射温度計の校正法とその精度評価
A New Method for Calibrating Radiation Pyrometers and Estimation of the Accuracy

栗田 邦夫(Kunio Kurita) 岩村 忠昭(Tadaaki Iwamura) 田村  清(Kiyoshi Tamura)
要旨 :
放射温度計の目盛校正には,標準として熱電対が使われているのが普通である。しかしこの方法では±5℃以内の精度維持は難しい。そこで,定点黒体炉を用いて自動光高温計を正確に校正し,これを熱電対に代わる標準として使用する体系を考え,その精度を検討した。理論解析および実験の結果から,その精度は次のとおり評価された。(1) 定点黒体炉による自動光高温計の校正精度は,再現性,系統誤差を含めて±1.0℃である。(2) 放射温度計を自動光高温計により校正する総合精度は±3.0℃である。この結果は,鉄鋼業における放射温度計の利用分野の拡大に役立つものと期待される。
Synopsis :
This study aims at making a new prectical standerd for the calibration of radiation pyrometers. For this purpose, a high-precison automatic optical pyrometer, whose temperature scale has been determined beforehand in reference to silver and copper points can be used as a standard thermometer instead of the conventionalPR thermocouple. The formar is more accurate than the latter in terms of effective emissivity of cavity, errors in the measuring system, and others. The emissivity of blackbody has been calculated by integral equation method, and then the systematic errors in the calibration evaluated as follows: An automatic optical pyrometer calibrated at the silver and copper points has an accuracy better than ±1℃ in the range of 800-1200℃; Radiation pyrometers can be calibrated by using the above automatic optical pyometer has an accuracy better than ±3℃ which is accurate enough for use in the steel industry.
本文(PDF: 10P/334kb)




(c)JFE Steel Corporation, 2003