■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.9 (1977) No.1.2
■■■■■■■■■■■■■■■■■■■

かたさ測定による鋼材の引張特性値の推定について
Estimation of Tensile Properties of Steels through Hardness Measurements

原  道彦(Michihiko Hara) 川井  豊(Yutaka Kawai)
要旨 :
かたさ試験は一般の機械的試験法のうちでもとくに簡単であり,しかも小さな試料で足りるので,他の試験法を代行できれば極めて有益な手段となり得る。このような観点から,古典的とも言えるマイヤーかたさの測定により実用鋼の引張特性値を推定する実用計算式を導いた。ヴィッカース試験機用に試作した小球圧子を用いるとわずか1cm2の被倹面積で上記推定用の測定を実施できる。構造用鋼の場合,下降伏点と引張強さを約5%以下の相対誤差で推定できた。普通のヴィッカースかたさもまた,引張強さの3倍の値を与える近似値として利用できる。その他,加工硬化指数や破断時の真ひずみの推定式をも導いた。
Synopsis :
The estimation of mechanical properties through a simple hardness test will be very advantageous because of the handiness of the test and small requirement of test material. In this report, a semi-theoretical and semi-empirical derivation of estimation formulae from the classical Meyer hardness has been performed for some static tensile properties of steels. Only 1cm2 of test surface will suffice for the above estimation when using small spherical indentors specially devised for use in a Vickers hardness tester. The relative errors in the estimation of lower yield point and tensile strength are expected to remain less than 5% in the case of ordinary structural steels. Other formulae can estimate work hardening exponent and true strain at fracture. One third of an ordinary Vickers hardness can also be used as a rough estimator of tensile strength.
本文(PDF: 8P/254kb)




(c)JFE Steel Corporation, 2003