■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.8 (1976) No.1
■■■■■■■■■■■■■■■■■■■

DI缶用素材としての連鋳底炭素A1キルド鋼の開発
Development of Continuously Cast Low Carbon Aluminium Killed Steel for D.I. Can

飯田 義治(Yoshiharu Iida) 上田 典弘(Tsunehiro Ueda) 江見 俊彦(Toshihiko Emi) 垣生 泰弘(Yasuhiro Habu) 阿部 英夫(Hideo Abe) 角南 秀夫(Hideo Sunami) 芳賀 雄彦(Takehiko Haga) 久々湊 英雄(Hideo Kuguminato)
要旨 :
DI缶用として必要な鋼板の品質特性を検討し,素材を連鋳工程で製造する技術を確立するに至った経過を述べた。DI法特有の厳しい加工法を絞り性,アイオニング性およびアイオニング加工後の伸びフランジ性で比較すると鋼種としては低炭素Alキルド鋼が適し,鋼板材質はr値1.3以上,結晶粒度9.0以上で,かつフランジ割れや表面欠陥の原因となる厚さ2.5μ以上の介在物が極力少ない清浄性に優れたものが望ましい。このような高品質の鋼板を連鋳工程で製造する試験を繰返した結果,1)取鍋溶鋼の脱ガス処理,2)タンディッシュへの注入時,ベローズ式シールと注入管の併用,3)2重堰付深型タンディッシュの使用,4)2本型浸漬ノズルの使用,5)高温注入,などの総合効果により安定して製造できるようになった。
Synopsis :
Properties of steel strip for deep drawing, ironing and flange elongation after ironing have been investigated. A low-C Al-killed steel strip with the Lankford value ≧1.3 and ferrite grain size number ≧9.0 is found most suitable among the steels examined. Flange crack and surface defects are effectively prevented by decreasing the amount of inclusions thicker than 2.5μ in the strip. A degassing followed by continuous casting process has been developed to commercially produce extra-clean low-C Al-killed steel for D.I. can use. The process is featured by the use of (1) sufficient RH-stirring of fully Al-deoxidized melt, (2) bellows type Ar gas shrouding with immersed type spout during teeming of the melt from ladle to tundish, (3) deep tundish with double dams, (4) two inverted Y type tundish nozzles and (5) teeming of the melt with sufficient superheat.
本文(PDF: 14P/456kb)




(c)JFE Steel Corporation, 2003