■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.7 (1975) No.4
■■■■■■■■■■■■■■■■■■■

自動車用加工性高張力冷延鋼板
High Strength Cold Rolled Steel Sheets with Good Formability for Automobiles

大橋 延夫(Nobuo Ohashi) 高橋  功(Isao Takahashi) 橋口 耕一(Koichi Hashiguchi) 古川 幸夫(Yukio Furukawa)
要旨 :
成形性の良い高張力冷延鋼板の製造方法について述べた。特別な焼鈍工程を用いない場合の鋼の強化は,おもに鋼の化学成分の調整により行われる。それには固溶硬化と析出硬化を利用する2つの方法がある。Si,Mn,P,Nb,Vなどの元素を添加した鋼板の降伏強度,引張強さと延性の関係を調べた。そして成形性と点溶接性を考慮して,引張強さ40〜60kg/mm2の冷延鋼板(APFC40〜60)の化学成分系は,T.S.40,45kg/mm2級は低C-Si-Mn系,T.S.50kg/mm2以上は低C-Si-Mn-Nb系とした。新しく開発した時効硬化型高張力冷延鋼板の性質についても報告する。
Synopsis :
Methods are discussed for the manufacture of high strength cold rolled steel sheets with good formability. Steels that have not been subjected to any special annealing process can be strengthened by controlling their chemical compositions. For this purpose, solid solution and precipitation hardenings are employed. The relations between yield strength, tensile strength and ductility are investigated on the steels to which Si, Mn, P, Nb, Ti, V, etc. are added. When taking into consideration of formability and spot weldability, the chemical compositions of cold rolled sheets having tensile strengths of 40-60kg/mm2 (APFC40-60) have been determined as follows; Low C-Si-Mn as the steels of T.S. 40, 45kg/mm2, low C-Si-Mn-Nb as the steels of T.S.≧50kg/mm2. The properties of newly developed age hardenable high tensile strength cold rolled steel sheets are also discussed.
本文(PDF: 10P/300kb)




(c)JFE Steel Corporation, 2003