■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.7 (1975) No.2
■■■■■■■■■■■■■■■■■■■

揚水発電所ペンストック補剛環用80kg/mm2級鍛鋼の製造について
Manufacturing Method of HT-80 Forging Steel for Ring Reinforcement of Penstock in Pumping-up Power Plants

佐藤 新吾(Shingo Sato) 狩野 征明(Masaaki Karino) 大井  浩(Hiroshi Ooi) 松居  進(Susumu Matsui) 早川 泰司(Yasushi Hayakawa) 後藤 義彦(Yoshihiko Goto)
要旨 :
最近,火力発電所における負荷の変動を減少させるために揚水発電所の建設がさかんに行われている。これらの揚水発電所の規模は巨大化し,ペンストック用材として高張力鍛鋼が要求されてきている。今回,1.5% Ni鋼を用い,粒界B量と熱処理条件を調整することによりペンストック補剛環用として肉厚360mmにもおよぶ80kg/mm2級鍛鋼を開発した。これらの結果を基礎にして奥清津揚水発電所向けに製造した補剛環の靱性と溶接性は要求される性能を十分満足するものであった。
Synopsis :
Recently, in order to decrease load fluctuation of thermal power plants, numerous pumping-up power plants have been constructed. The capacities of those plants have become gigantic and higher strength forging steel is required for penstock of the pumping-up power plant. 80kg/mm2 class forging steels up to 360mm thickness for ring reinforcements of penstock have been developed by controlling the boron content of grain boundary and heat treating conditions of 1.5% Ni steel. Consequently, notch toughness and weldability obtained of ring reinforcements are satisfactory for the Okukiyotsu pumping-up power plant.
本文(PDF: 15P/465kb)




(c)JFE Steel Corporation, 2003