■■■■■■■■■■■■■■■■■■■
川崎製鉄技報
KAWASAKI STEEL GIHO
Vol.4 (1972) No.2
■■■■■■■■■■■■■■■■■■■

大型圧延H形鋼の残留応力と曲げ耐荷力
Effect of Residual Stress on Ultimate Bending Strength of Rolled H-Shapes

石渡 正夫(Masao Ishiwata) 浜田 敬之介(Keinosuke Hamada) 佐々木  徹(Toru Sasaki) 中西 輝行(Teruyuki Nakanishi) 近藤 信行(Nobuyuki Kondo)
要旨 :
圧延H形鋼は圧延中および冷却過程において,フランジとウエブとの間に温度差を生じ,内部に残留応力を生じている。とくに桁高の大きい圧延H形鋼では残留応力は大きくなる傾向にある。本研究は圧延H形鋼の残留応力を測定し,残留応力が曲げ耐荷力におよぼす影響を明らかにすることを目的としている。実験の結果,通常の圧延H形鋼に導入されている残留応力は20kg/mm2以内であり,この程度では設計荷重では実用上問題となる残留変形,剛性の低下はない。また曲げ耐荷力に対しては残留応力の影響はなく,塑性ひずみが十分進行したのち,圧縮側フランジの横座屈により破壊していることもわかった。
Synopsis :
The rolled H-shapes, in the process of their rolling and cooling, bring about a difference in temperature between the flange and the web and generate residual stress inside. Residual stress is apt to become larger especially as the web is higher. This study is aimed at measuring the residual stress of rolled H-shapes and clarifying its effect on the ultimate bending strength of the H-shapes. As the result reveals, the residual stress locked up in the usual rolled H-shapes is within 20kg/mm2. This means that with the residual stress remaining so low, no reduction practically will occur in the residual deformation or stiffness though this often becomes a matter of concern in respect of design load. Moreover, no effect of residual stress is observed on the ultimate bending strength, and even if the rolled H-shapes are broken, it is found due to the lateral buckling of compression of the flange after plastic strains have advanced considerably.
本文(PDF: 16P/498kb)




(c)JFE Steel Corporation, 2003